We know that once the stenter has a problem of running sideways, the consequences are often very serious. Therefore, after finding out the specific reason, we must deal with it immediately to avoid more serious consequences. So, how to control it? First of all, when we operate the tenter setting machine, we should pay attention to observe the operation status of the equipment.
During the operation of the tenter setting machine, it is also necessary to check and adjust the stacking state of the cloth waiting to be processed in advance to ensure the stacking adjustment, so that the stability of the cloth can be maintained during the feeding process.
Secondly, the staff should also properly adjust the distance between the door width and the edge suction device according to the actual processing situation, and also adjust the pressure appropriately.
The third point is that when inspecting the fabric, the defective fabric should be selected in advance, so as to prevent the edge-running phenomenon caused by the rotten edge.
Fourth, we also need to set a baffle plate or a ruler wheel on the crossbar at the cloth feeding end of the tenter setting machine, which can reduce the lateral change of the cloth surface, and at the same time, it can also swing left and right, so as to avoid running edge.
Fifth, the staff should operate the tenter setting machine correctly and try to run it stably. In addition, it is also necessary to properly adjust the tension of the machine according to the tightness of the fabric structure. Remember, do not use too much tension, otherwise there will be rotten edges or running edges. If the equipment is equipped with an overfeeding device at the same time, care should be taken to control the overfeeding, so as not to drop the needle and cause side run. During the operation of the stenter, we also need to pay attention to the surrounding environmental conditions. For example, a larger screen can be used to solve the interference problem of gusts. At the same time, the equipment should be regularly inspected and maintained, and damaged parts should be replaced in time.
https://www.sunwinmachinery.com/
